- All our transfers are designed to be used
more than once. The iron’s temperature setting, the length of
time the iron is on the transfer, and the amount of pressure placed
on the iron will affect the transfer.
- These three factors determine the number of
times that the design can be clearly transferred. Therefore, if you
plan to use the transfer several times, use the least amount of heat
and the shortest amount of time possible to transfer the design.
- Always prewash your garment or material (ours
is already prewashed) before transferring your design; do not use
fabric softener. Press the garment to give you a smooth surface.
- Preheat iron for five minutes on appropriate
setting for fabric being used. Do Not use steam.
-
- The ink transferred is the reverse to what
it will appear on garment. (If working directly onto the garment)
always test on a scrap similar to the material.
-
- Cut out your paper transfer.
-
- Place transfer, inked side down, on back of
fabric. (Make sure you leave enough fabric around the edges of your
design for your hoop to fit over).
-
- Place iron on transfer; hold for about five
seconds, move iron to another position on transfer so all areas under
steam holes are transferred.
-
- Carefully lift one corner of transfer to see
if design has been transferred to fabric. If not place iron on transfer
for a few more seconds.
-
- Your design is ready to put into you hoop.
|
